Generator batteries need to be connected to a battery charger so that they are ready when you need them most.

A generator battery charger is different than the battery chargers for your car. A generator battery charger is meant to keep your battery charged by supplying a precise “float” voltage to it.

This voltage should be neither too low, or your battery will be undercharged, nor should it be too high because it will shorten it’s life.

We chose to sell the Charles Industries generator battery charger simply because they are the best, most reliable battery chargers money can buy.

Your business depends on having reliable power. You’ve invested in a top quality ASCO Automatic Transfer Switch, and a automatic start generator. Keep the system reliable with a quality battery charger. Remember that the best generator transfer switch, and the best generator is only as reliable as the battery that gets it started.

C-CHARGER®
FERRORESONANT BATTERY CHARGER
MODEL ‘CI1205C’ – AUTOMATIC FLOAT CHARGER

Stainless steel for corrosion resistance
Ferroresonant transformer for reliability
Fully automatic…nothing to adjust or set. (This means that the charger will never “drift” off voltage, damaging your battery, or leaving it undercharged.)
DC output set at 2.33 volts per cell, the correct float voltage for lead acid batteries
DC ammeter to indicate charge rate
Combination switch; On/Off, pilot light, AC circuit breaker
Cannot discharge battery during AC failure
Sealed silicon diode, full wave, rectifier
Isolated output – no direct AC to DC connection
Two-year limited warranty
The Charles Industries CI series is the best choice for dependability and durability.

Safe to say, there is no other float charger built like a C-CHARGER®  Rugged #304 grade stainless steel forms the tough housing that withstands virtually any environmental effects…stifling heat, dripping wet humidity or salt air so strong it could almost crystallize while you watch!  Consequently, there’s no rusting, no corrosion nor any fragile painted finishes to waste away.

Electrically, the C-CHARGER® is a paragon of efficiency and simplicity.  It uses a ferroresonant transformer which, by its nature, is self-regulating and completely devoid of any complicated circuits that could possibly burn out.  There are no tubes or delicate electronics to fail or to cause radio frequency interference (RFI).

Voltage output to the batteries remains at a safe and constant DC level from full load to no load even if the AC power runs as high as 135 VAC or as low as 100 VAC.  All components are designed to operate safely and continuously in an ambient temperature as high as 125° F.